GPOE-USBC-25W IEEE802.3at Compatible Gigabit Splitter POE 25 Watt Power to Type C Device
IEEE802.3af/at PoE Input
USB-C 25 Watt Output
This device works with any 802.3at switch, it takes the 44 to 56 volts from the PoE switch, and converts that voltage to USB-C standard voltages and removes power from the data - it works with gigabit data speeds. Can also work with an 802.3af switch if the ouput is used below 13 watts.
Intended for use with similar PoE switches - this PoE solution appears like a standard Class 4, 25 watt device.
The PoE switch can send either polarity, and only 2 pairs are required for power, 4 pairs for gigabit data, 2 pairs for 10/100.
The ouput is fully isolated from the input voltage. Grounding is of no concern.
The ouput power is on a USB-C connector. The voltage is defined by a negotiation between the attached device and the GAT-USB-C. The supported voltages are 5 volts 3 amps
9 volts 2.4 amps 12 volts 2 amps 15 volts 1.7 amps 20 volts 1.3 amps The USB-C connector offers no data - use the RJ45 for data.
Data speed 10/100/1000 mb/s Input Voltage 802.3af / 802.3at / passive 44 to 57 volts at 600 mA max Output Voltage determined by attached device Internal power use 900 mw Operating Temperature 0°C - 50°C Data Transparent Isolation 1500 Volts Size 107 x 50 x 25 mm 802.3at Class 4 PoE Power input Pins 1&2 and 3&6 - either polarity - mode A 4&5 + and 7&8 minus - mode B Shielded RJ45
Data output Shielded RJ45 Power out DC connector female USB-C LED status on Female RJ45 Right - Power In active = Green Left - Power out active = Amber
GAT-5V20W - Fixed Voltage
GAT-5V10W - lower power and cost AT-4 - high power injector GAT-Extender - long runs